Selectronic SP PRO - Model-Specific Installation Procedures

To Next Page

To Previous Page













1 -







Installation of SPMC models

Main Page

Table of Contents4
Introduction6
Australian/New Zealand Warranty6
Using this Manual6
Included in this Package7
Glossary of Terms7
Benefits of SP LINK7
Solar Hybrid Support and Grid Feed Systems8
Product Overview8
Mobile Systems9
Off Grid Stand Alone Power Systems (SPS)9
Precautions and Safety10
Who Should Install this Unit10
Multiple Hazardous Energy Sources10
Preparation11
Installation11
Maintenance11
Inverter May Start Automatically11
Backup Generator May Start Automatically11
Battery11
- Installation12
- Installation-General Requirements12
- Environmental Considerations13
- Effects of Altitude on the SP PRO13
- Preparation14
- Installation of SPMC Models15
- Installation of SPLC Models18
- Battery Cabling Requirements21
- Battery Fusing / Circuit Breakers21
- DC Wiring SPMC Models22
- Primary DC Terminal Connections - SPLC22
- DC Wiring SPLC Models22
- Expansion Card Warning - 120VDC Model23
- Current Shunt Wiring23
- Battery Temperature Sensor23
- Battery Wiring (DC) Preparation24
- AC Wiring25
- Earth Wiring25
- Residual Current Device (RCD) Type Recommendation25
- AC Wiring Preparation26
- Backup Generator (Advanced Feature) Control Wiring27
- Serial Port Connection27
- Gland Plate Fit out27
- Initial Start up Procedure27
- Labelling27
- Installation-System Configuration28
- Managed AC Coupled Preparation29
- Battery Capacity31
- Generic AC Coupled Preparation32
- Three Phase Preparation33
- Split Phase Preparation33
- DC Couple Charge Controller Preparation34
- Installation-Ancillary Components36
- Inputs and Output36
- External AC Source Contactor39
- Adding a Backup Generator (Solar Hybrid)40
- Adding a Generator (off Grid)41
- Installation-Communications42
- Communications Overview42
- RS232 Serial Communications43
- USB Communications43
- Wireless SP PRO to SP LINK44
- SP PRO Ethernet Adaptor45
- RS485 - KACO Link45
- Installation-Configure with SP LINK46
- Overview46
- Configuring the SP PRO for All System Configurations47
- Installation-Commissioning48
- Introduction48
- Diagnostics During Commissioning48
- Common System Checks49
- Checking Managed AC Coupled Systems51
- Checking Generic AC Coupled52
- Checking DC Coupled52
- Three Phase and Split Phase Systems53
- External AC Source Contactor54
- External Generator55
- Controls and Indicators56
- User Interface56
- SP PRO Operation58
- Battery Management59
- Battery State of Charge (Soc) Monitoring and Control59
- Battery Voltage Monitoring and Control59
- Battery Charging Operation60
- Battery Charging Cycle61
- Battery Temperature Compensation62
- Renewable Management62
- Generator Controls for off Grid63
- Backup Generator Controls (with Option)63
- Inverter External Alarm63
- Service and Maintenance64
- Cleaning the Fan and Fan Filter64
- Monitoring the Operation of the SP PRO64
- Resetting Inverter with or Without Restoring Factory Default Settings65
- System Shutdown65
- Installer Maintenance of SP PRO65
- System Maintenance65
- Troubleshooting66
- Front Panel Indicators66
- Troubleshooting with SP LINK68
- AC Power Problems69
- Battery Problems69
- Grid Related Problems69
- Off Grid Generator Start/Stop Problems70
- Inverter Startup Problems71
- Appendix A Specifications72
- Standards Compliance72
- Product Specifications72

Selectronic SP PRO - Model-Specific Installation Procedures

Table of Contents

Other manuals for Selectronic SP PRO

Related product manuals