ENG
SETTING MANUAL
17
Picture 13
Parameters S are by default (factory) settings locked.
Which data and settings are hidden is set in parameter S3.1.
i
Picture 14
Successive Nr.
of the line
Group
name
Parameter
Entrance
Room unit data d1
This group is sort of DD2+ ID. In this group are information about DD2+.
The information are displayed in the following order:
- [d1.1] room unit type (DD2+)
- [d1.2] software version
- [d1.3] heating or cooling
- [d1.4] built-in temperature sensor calibration
- [d1.5] battery voltage
To Next Page
Loading...
