6
OPERATING INSTRUCTIONS OVERVIEW
Startup
1) Turn on the power switch located on the back of the counter near the power socket. The display
will read all 8’s, indicating that the unit is completing a self-check process and checking each
sensor.
2) 0 will appear to indicate that the counter has successfully completed its self-diagnostic process
and is now in standby mode and ready to be used.
3) If the machine encounters a problem during the self-check startup process, an error message
will appear on the display. For example: E1
E6
Please refer to the Startup Malfunction Codes to determine what the error code represents.
Basic Counting Process
1) Place the banknotes in the hopper and the counter will auto-start the counting process. It will
count all the banknotes in the hopper and show the total count on the display.
2) To continue counting, remove all of the counted banknotes from the stacker and place the next
stack of banknotes in the hopper. The counter will begin counting from "0" again.
3) If the banknotes in the stacker are not removed before placing additional banknotes into the
hopper, the counter will restart automatically but will add the additional banknotes to the previous
total.
Error Codes During The Counting Process
During the counting process, if a suspect counterfeit banknote is detected or a feeding error occurs
(such as double note, chain note or half note), the counter will stop counting and the appropriate
error code will be displayed. Please see the Counting Error Code List to interpret the meaning
of any error codes.
NOTE: Avoid placing damp or wet banknotes into the machine. Always be sure to remove
any paper clips, rubber bands, staples or other items attached to the banknotes before counting.
If the banknotes are curled, folded or bent, flatten them before running them through the
machine.
To Next Page
Loading...
