10C Evo
10C Evo Manual
Motorcycle Bluetooth Communication & Camera System
1. Turning On/Off the Headset
To power on the headset, press the Jog Dial and the Phone Button at the same time until the blue LED
appears. To power off the headset, press the Jog Dial and the Phone Button at the same time until the
red LED appears briefly.
2. Adjusting Volume
You can easily adjust the volume by rotating the Jog Dial.
3. Checking the Battery Level
When the headset is powering on, the red LED flashes rapidly indicating the battery level.
4 flashes = High, 70~100%
3 flashes = Medium, 30~70%
2 flashes = Low, 0~30%
When you power on the headset, keep pressing the Jog Dial and the Phone Button simultaneously for
about 3 seconds until you hear high tone triple beeps. Then you will hear a voice prompt indicating the
battery level is high, medium, or low.
4. Charging the Battery
You can charge the headset by connecting the supplied USB power & data cable into a computer’s USB
port or USB wall charger. The LED turns red while the headset is charging and turns blue when it is fully
charged. It takes about 3.5 hours to be completely charged.
5. Pairing with Mobile Devices - Phone, Music
1. Press and hold the Phone Button for 5 seconds until the LED flashes red and blue alternately and you
hear multiple beeps.
To Next Page
Need help?
General
