Need help?Do you have a question about the Sena 10C EVO and is the answer not in the manual?
General| Bluetooth Version | Bluetooth 4.1 |
|---|---|
| Certificates | CE, FCC, IC |
| Bluetooth Profile | HFP, HSP, A2DP, AVRCP |
| FM Radio | Yes |
| Video Recording | 1080p |
| Video Recording Time | 2 hours |
| External Memory | MicroSD card |
| Microphone | Built-in |
| Speaker | Built-in |
| Audio | Noise Control |
Steps to install the main unit using the clamp unit: loosen screws, insert back plate, tighten screws, attach unit.
Further steps for installing the main unit with the clamp unit, including microSD card insertion.
Attaching the main unit via a glued mounting plate when the clamp unit is not suitable.
Attaching speakers to ear pockets inside the helmet using hook and loop fasteners.
Attaching the boom microphone to the helmet's interior shell using hook and loop fasteners.
Attaching the wired microphone to the inside of the helmet's chin guard.
Adjusting the vertical angle (360°) using the wheel on the gear clamp unit.
Adjusting the vertical angle (8°, 20°, 32°) using the clamp unit before helmet mounting.
Starting/stopping video recording and approximate recording times for different resolutions.
Steps to pair the headset with a mobile phone or Bluetooth stereo device using PIN 0000.
Procedure for pairing the headset with up to three other Sena headsets for intercom.
Instructions for call management: answering, ending, rejecting, and transferring calls.
Procedures for initiating and terminating two-way intercom conversations with other users.
Instructions for establishing three-way and four-way intercom conferences.
Adjusting settings like speed dial, audio source priority, and VOX via software.
Selecting photo modes (single/burst) and video modes (normal, timelapse, loop).
How to reset the headset using the pinhole button for minor operational issues.
Restoring the headset to its original factory default settings via the Phone Button.
To Next Page
