10C EVO
15
English
4.5 Photo Taking
4.5.1 Single Shot Mode
To take a single photo, set the photo mode setting in the camera
conguration to be single shot mode. Tap the Camera Button to take a
photo. The green LED will ash and you will hear a shutter sound.
4.5.2 Burst Shot Mode
Burst shot takes 8 photos. To take multiple photos, set the photo mode
setting in the camera conguration to be burst shot mode. Tap the
Camera Button to take multiple photos. The green LED will ash and
you will hear shutter sounds.
Note:
• If you are recording in 2160p/30fps of video resolution, you cannot take a
photo.
• The camera resolution is fixed to 12MP. However, when you take a photo
during video recording, the photo resolution is fixed to 8.3MP.
4.6 Video Tagging
Video Tagging allows the camera to record video continuously, but
save only the important events.
It creates video les of past, present, and future with each footage
having an assigned length of time (3 minutes).
1. When you encounter an event that is worth saving, press and hold
the Camera Button for 3 seconds. You will hear a voice prompt,
“Video tagging”.
2. When Video Tagging is completed, you will hear a voice prompt,
“Tagging complete”.
Note:
• Video Tagging can be operated only in the Loop Recording mode. In
order for video files of past, present, and future to be saved, Video
Tagging must be started at least 3 minutes after Loop Recording starts.
• Video Tagging recorded files are stored in EVENT folder.
To Next Page
Loading...
Need help?
General
