10C EVO
29
English
14.2 Software Conguration Setting
You can change the settings of the headset through the Sena Device
Manager or the Sena App.
14.2.1 Speed Dial
Assign phone numbers for speed dialing to make a phone call quickly.
14.2.2 Audio Source Priority (Default: Intercom)
Audio Source Priority allows you to select the priority between the
intercom and music (which includes GPS app instructions and
message notications) from a smartphone. If the intercom is selected
as the audio source priority, your music will be interrupted during an
intercom conversation. If music is selected as the audio source priority,
intercom conversations will be interrupted while your music is heard.
Note:
Audio Source Priority is active only when Audio Multitasking is disabled.
14.2.3 Audio Boost (Default: Disable)
Enabling Audio Boost increases the overall maximum volume.
Disabling Audio Boost reduces the overall maximum volume, but
delivers more balanced sound.
14.2.4 VOX Phone (Default: Enable)
If this feature is enabled, you can answer incoming calls by voice.
When you hear a ringtone for an incoming call, you can answer the
phone by saying a word such as “Hello” loudly or by blowing air into
the microphone. VOX phone is temporarily disabled if you are
connected to intercom. If this feature is disabled, you have to tap the
Phone Button to answer an incoming call.
14.2.5 VOX Intercom (Default: Disable)
If this feature is enabled, you can initiate an intercom conversation
with the last connected intercom friend by voice. When you want to
start intercom, say a word such as “Hello” loudly or blow air into the
microphone. If you start an intercom conversation by voice, the
intercom terminates automatically when you and your intercom friend
remain silent for 20 seconds. However, if you manually start an
intercom conversation by tapping the Jog Dial, you have to terminate
the intercom conversation manually. However, if you start intercom by
voice and end it manually by tapping the Jog Dial, you will not be able
to start intercom by voice temporarily. In this case, you have to tap the
Jog Dial to restart the intercom. This is to prevent repeated unintentional
intercom connections by strong wind noise. After rebooting the
headset, you can start intercom by voice again.
To Next Page
Loading...
Need help?
General
