10C EVO
30
14.2.6 HD Voice (Default: Disable)
HD Voice allows you to communicate in high-denition during phone
calls. This feature increases the quality so that the audio will be crisp
and clear during phone call conversations.
If this feature is enabled, incoming phone calls will interrupt intercom
conversations and audio from the SR10 will not be heard during
intercom conversations. Three-Way Conference Phone Call with
Intercom Participant will not be available if HD Voice is enabled.
Note:
1. Refer to the manufacturer of your Bluetooth device that will be connected
to the headset to see if it supports HD Voice.
2. HD Voice is active only when Audio Multitasking is disabled.
14.2.7 HD Intercom (Default: Enable)
HD Intercom enhances the two-way intercom audio from normal
quality to HD quality. HD Intercom will become temporarily disabled
when you enter into a multi-way intercom. If this feature is disabled,
the two-way intercom audio will change to normal quality.
Note:
1. The intercom distance of HD Intercom is relatively shorter than that of
normal intercom.
2. HD intercom is active only when Audio Multitasking is disabled.
14.2.8 Voice Prompts (Default: Enable)
You can disable voice prompts by software conguration setting, but
the following voice prompts are always on.
– Headset conguration setting menu, battery level indicator, speed
dial, FM radio functions
14.2.9 RDS AF Setting (Default: Disable)
Radio Data System (RDS) Alternative Frequency (AF) Setting allows
a receiver to re-tune to the second frequency location when the rst
signal becomes too weak. With RDS AF enabled on the receiver, a
radio station with more than one frequency can be used.
To Next Page
Loading...
Need help?
General
