Sena 3S - Troubleshooting Sena 3 S Intercom Failure; Sena 3 S Intercom Reconnection Process; 7. Sena 3 S Configuration Settings

3S
24
mobile phone call because intercom has lower priority than mobile
call. You have to hang up the mobile phone call to make or receive an
intercom call.
Intercom Failure
When you try to start an intercom conversation with an intercom friend
who is already having a mobile phone call with another person, you will
hear a low tone double beep signifying a busy signal. You will also hear a
voice prompt saying “Intercom failed, try again later”. In this case, you
have to try again later. On the other hand, the intercom friend will hear
4 high tone beeps alerting them that there is an incoming intercom call.
Intercom Reconnection
If your intercom friend goes out of range while having an intercom
conversation, you may hear static noise and eventually the intercom will
be disconnected. In this case, the 3S automatically tries to reconnect
the intercom every 8 seconds. You will hear high tone double beeps until
the intercom is reestablished. If you don’t want to make a reconnection,
press and hold the (–) Button for 1 second to stop the attempt.
7. 3S CONFIGURATION SETTING
You can set the conguration of the 3S by the voice menu instruction as
below.
1. To enter into voice conguration menu, press and hold the (+) Button
for 10 seconds until the LED shows solid blue and you hear high tone
double beeps. You will hear a voice prompt saying “Conguration
menu”.
2. Press the (+) Button to navigate between menus. You will hear voice
prompts for each menu items as below.
3. You can enable or disable the feature or execute the command by
pressing the (–) Button.
4. If any button is not pressed within 10 seconds, the 3S will exit the
conguration and goes back to standby.
5. If you want to exit the conguration immediately, press and hold the
(+) Button until you hear a voice prompt, “Exit conguration”, and
press the (–) Button.