Safety Precautions
Please ensure that the product is properly used by observing the warnings and
cautions below to prevent any risk and/or damage to property.
Product Storage and Management
• Keep the product free of dust. It may damage mechanical and electronic parts of
the product.
• Do not store the product in high temperatures as this may reduce the life span of
electronic devices, damage the battery, and/or melt plastic parts of the product.
• Excessive heat (e.g. exhaust heat) can cause damage to the decoration, the inner
shell of the helmet and the interior lining.
• Do not store the product in cold temperatures. Abrupt changes in temperatures
may cause condensation and damage electronic circuits.
• Do not clean the product with cleaning solvents, toxic chemicals, or strong
detergents as this may damage the product.
• Direct contact with motor fuel, thinners or solvents can destroy the structure of the
inner and outer shell. Make sure the helmet does not come into contact with such
substances, even for cleaning purposes.
• Do not paint the product. Paint may obstruct moving parts or interfere with the
normal operation of the product.
• Do not drop or otherwise shock the product. It may damage the product or its
internal electronic circuits.
• Do not disassemble, repair or modify the product as this may damage the product
and invalidate the product warranty.
• Do not store the product in humid environments, especially for long time storage.
• The helmet should be replaced after 5 to 7 years, depending on use and care.
Although the outer shell is in principle capable of a longer service life, the occurrence
of material fatigue and wear to other components, as well as the overall action of the
helmet and the unknown conditions in which the helmet has been used, make it
advisable for your own safety to replace the helmet after this period of use.
• Original components (in particular on the outer shell, inner shell and restraint
system) should not be altered or removed. The fitting of additional parts from other
manufacturers that have not been recommended can reduce the protective effect
and renders the DOT certification and all warranty and insurance claims invalid.
• Use only original parts, replacement parts and accessories that Sena has expressly
approved for your helmet.
Product Use
• Motorcycling is associated with particular risks and dangers for the rider and
passenger. These risks and dangers can be reduced, but not eliminated completely,
by wearing a helmet. It is impossible to state precisely what the protective effect of a
helmet will be in the event of an accident. Safe riding techniques, adapted to the
particular road and weather conditions, are essential for your safety.
• To provide adequate protection, the helmet must fit well and be securely fastened.
• Always fasten the chinstrap before setting off and check that the fastening system
and strap are correctly in position.
• Never ride with the chinstrap unfastened or incorrectly adjusted. The chinstrap
must be correctly
To Next Page
Loading...
