To Next PageTo Next Page
Need help?Do you have a question about the Senco FramePro 325XP and is the answer not in the manual?
Read and understand the SAFETY INSTRUCTIONS manual before using the tool.
Always wear OSHA-required safety glasses with side shields to prevent eye injuries.
Keep the tool pointed away from yourself and others and connect air to the tool.
Do not use tools that leak air or require repair for safe operation.
Steps for loading nails into the magazine and preparing the feeder shoe.
Describes the restrictive firing mode and how to switch to Contact-Actuation.
Explains the two ways nails can be driven in Contact Actuation mode.
Read the CSSR for safety information on trigger modes and potential injury reduction.
Instructions to disconnect air and rotate the wheel to adjust fastener depth.
Steps to clear jammed nails, including disconnecting air and removing fasteners.
Procedures for removing, clearing jams, and reattaching the magazine.
Connect air supply, replace fasteners, and pull the feeder shoe back.
Description of the tool's lockout feature that prevents firing when nails are low.
Ensure all screws are kept tight to prevent unsafe operation and parts breakage.
Inspect the safety element and trigger for free movement daily. Do not use if they stick or bind.
Squirt pneumatic oil into the air inlet twice daily using Senco oil to prevent damage.
Wipe the tool clean daily and inspect for wear. Use non-flammable cleaning solutions sparingly.
Repairs not described should only be done by trained, qualified personnel. Contact SENCO.
Addresses air leaks near the top or sluggish operation by checking screws or using a repair kit.
Addresses air leaks near the bottom or poor return by tightening screws, cleaning, or using a repair kit.
For other problems not listed, contact SENCO for assistance.
Details the minimum and maximum fastener lengths for the FramePro 325XP model.
Details the minimum and maximum fastener lengths for the FramePro 400XP model.
Specifies the minimum and maximum operating pressure in psi and bar.
Details the air consumption in scfm and liter/min at 60 cycles per minute.
Identifies the standard air inlet connection type (3/8 in. NPT).
Provides the weight of the tools in lbs and kg.
Indicates the number of fasteners each magazine can hold.
Lists the height, length, and width of the main body for each tool model.
How to get more information or a catalog for SENCO accessories using code #MK336.
Outlines the specific warranty duration for various SENCO tool models.
Lists conditions and parts not covered by the warranty.
Details the conditions that must be met for the warranty to be honored.
Describes the process for tool replacement in case of destruction by a natural disaster.
Explains the policy for returning the product within thirty days for a full refund.
General