What to do if my Senco FramePro 701XP Nail Gun has an air leak near the top or is operating sluggishly?
If your Senco Nail Gun has an air leak near the top or is operating sluggishly, verify the air supply and tighten the screws. Alternatively, install Repair Kit YK0243.
What to do if my Senco FramePro 701XP Nail Gun has an air leak near the bottom or has poor return?
If your Senco Nail Gun has an air leak near the bottom or experiences poor return, clean the tool and tighten the screws. You may also need to install Repair Kit YK0244.
General| Fastener Type | Framing Nails |
|---|---|
| Magazine Angle | 21 degrees |
| Operating Pressure | 70 - 120 PSI |
| Firing Mode | Sequential or contact |
| Power Source | Pneumatic |
| Magazine Capacity | 60 nails |
| Fastener Gauge | 0.113 - 0.131 in |
| Fastener Length | 2" - 3.5" |
| Nail Length | 2 to 3-1/2 inches |
| Nail Gauge | .113 - .131 in |
Provides guidance on how to use the Finish Nailer model.
Emphasizes staying alert, using common sense, and avoiding use when tired or under the influence.
Warns against using the tool in explosive atmospheres or near flammable materials.
Instructions on how to load fasteners into the nailer magazine.
Explains Contact-Actuation and Sequential-Actuation trigger functions.
Guide to setting the depth at which fasteners are driven.
Steps to follow when a fastener becomes jammed in the tool.
How to adapt the tool for non-toenail applications using a no-mar pad.
Instructions for rotating the deflector to change exhaust air direction.
Describes the safety feature preventing unintended activation.
Daily checks to ensure safe operation and component integrity.
Routine procedures for oiling and cleaning the tool.
Solutions for air leaks near the top and slow tool performance.
Solutions for air leaks near the bottom and improper tool return.
Guidance for issues not covered by specific troubleshooting steps.
To Next Page
