Drive fasteners into work surface
only; never into materials too
hard to penetrate.
Do not drive fasteners on top of
other fasteners or with the tool
at too steep of an angle; the
fasteners can ricochet and hurt
someone.
Do not drive fasteners close to
the edge of the work surface.
The workpiece is likely to split
and the fastener could fly free or
ricochet and hit someone.
Tool may eject a fastener when
connected to air supply; there-
fore, remove all fasteners from
tool before connecting air.
Never use tool if trigger or
springs have become inopera-
ble, missing or damaged. Do not
tamper with or remove trigger or
springs.
Disconnect tool from air before
doing tool maintenance, clearing
a jammed fastener, leaving work
area, moving tool to another
location, or handing the tool to
another person.
4
To Next Page
Loading...
