Make sure all screws and caps
are securely tightened at all
times. Make daily inspections for
free movement of trigger. Never
use the tool if parts are missing
or damaged.
Never use a tool that leaks air or
needs repair.
®
Use only parts, fasteners, and
accessories recommended or
sold by SENCO. Do not modify
tool without authorization from
SENCO.
Use only clean, dry, regulated
compressed air at recommended
pressure.
200 psig
13.7 bar
Do not connect tools to air pres-
sure that potentially exceeds 200
psig or 13.7 bar.
Air compressors used to supply
compressed air to this tool must
comply with requirement ANSI/
ASME B 19.1–1995 (U.S.),
“Safety Standard For Air Com-
pressor Systems.”
Air hose must have a minimum
working pressure rating of 150
psig (10.3 bar) or 150% of the
maximum pressure produced in
the system, whichever is higher.
5
To Next Page
Loading...
