Sencor SBR 930 SS - TROUBLESHOOTING GUIDE Wie. Cei Cceccacosstisisacccacshsnatstueviecasqeasstcocsidenodcsieessigstciarccutunsreesnasvestacmranesiucesietenddesedurssazandssteontaningsd

BREAD MAKER
SBR 930 SS
BAKING TROUBLESHOOTING GUIDE
No. | Problem Cause Solution
Disconnect the bread maker from
Some ingredients got stuck to the the power supply and clean the
Smoke is escaping heating element or they got close to heating element. Use caution to
1. from the vents it. If this happen during the first use, it | prevent burns. During first use, dry
during baking. may be caused by oil burns that stayed | the machine by switching it on and
on the surface of the heating element. | starting baking programme. Keep the
lid open.
You are using the bread warming
2 The bottom crust is | function, and leaving the bread inthe | Take the bread out earlier and do not
` too thick. machine for too long. That causes water | use the warming function.
loss and drying, mainly on the bottom.
The bread could i n T
be removed from The kneader is stuck to the shaft inside g ok
3. A ; : R and submerge the kneader in it for
the container with the baking container. $ :
peta het about 10 minutes. Then remove it and
difficulties only. ;
clean it thoroughly.
Select other, more suitable
1. Incorrectly selected programme.
programme.
2. After you started the programme,
The ingredients you have opened the lid several Do not open the lid during the last
times; the bread is dry and the crust | rising period.
are net thoroughly is too light - not cris
4. mixed and the 9 Py:
baking is not Inspect the hole in the kneader.
satisfactory. 3. The resistance during the mixing Remove the baking container and turn
is too big, the kneader is barely on the kneading process without the
moving and not mixing all dough. If the appliance does not seem
ingredients well. to work properly, contact authorized
service centre.
After you have Press the ,,Start/Stop” button and
pressed the ,,Start/ : p disconnect the machine from the
n The inner temperature in the bread :
5; Stop” button the makeristoo hich wall outlet. Then remove the baking
display shows ,,H: gn. container, open the lid and let the
HH” bread maker cool down.
Inspect whether the baking container
You can hear the p . PIR 7 .
i The baking container is incorrectly is correctly attached, if the dough was
motor running but : : 3
6. thedoudh isnot attached or the volume of the dough is _ | prepared according to the correct recipe
; 9 too big for the mixing. and if all ingredients were weighted
being kneaded.
properly.
The bread is so big Too much of yeast, flour or water or too Check theAbovementioned factors
a ee A ‘ and lower the amount of applicable
TA that it is beginning high temperature of the surrounding ¢ ‘
3 . ingredients or the temperature
to press on the lid. environment. :
accordingly.
Copyright © 2012, Fast ČR, a.s. Revision 06/2012