Sencor SRV 9550BK - Electrical Safety

08/2020
- 3 -
Copyright © 2020, Fast ČR, a.s.
Laser
The laser sensor meets the laser safety class according to
standard EN 60825-1.
■ When using, handling or performing maintenance tasks on the
robotic vacuum cleaner with alaser sensor, always adhere to the
following instructions:
- Prior to any handling, turn off the robotic vacuum cleaner using
the power button.
- Do not point the laser beam at people.
- Do not look into the direct or reflected beam of the laser.
- Modifications or repairs of the laser sensor not performed by an
authorised service centre are forbidden.
Warning:
Not following the instructions contained in this
user‘smanual may result in dangerous irradiation!
Electrical safety
■ Before connecting the adapter to apower socket check that the
technical details on the rating label match the electrical voltage
in the socket.
■ Connect the power adapter only to aproperly grounded power
socket. Do not use an extension cord.
■ Do not disconnect the power adapter from the power socket by
pulling on the power cord. This could damage the power adapter
or the power socket. Disconnect the power adapter from the
power socket by pulling on the plug.
■ Do not place the power cord of the power adapter over sharp
objects. Make sure that the power cord does not hang over the
edge of atable and that it is not touching aheated or hot surface.