EN - 8
7. Set-up
1. Make sure that the paper shredder is switched off (slide switch 4 at the OFF position) before
plugging it into a socket.
2. Connect the power cord 1 to a socket.
3. Set the slide switch to the AUTO position. The paper shredder is now ready for use.
It is in the standby mode.
8. Shredding
WARNING!
Risk of injury!
Handling the paper shredder improperly may result in injury.
- Hold the paper by both sides when inserting into the feed slot. Make sure that your fingers do not
get too close to the feed slot.
- Only hold the CD by the outer edge when inserting into the feed slot. Make sure that your finger is
not in the CD hole, this can cause injury when the CD is drawn in.
- Hold the credit card by its narrow side when inserting into the feed slot. Make sure that your
fingers do not get too close to the feed slot.
NOTICE!
Risk of damage!
Improper handling of the paper shredder may result in damage to the paper shredder.
- Do not operate the paper shredder for longer than 3 minutes without interruption. Allow it to cool
down to room temperature first before restarting operation.
- Do not feed damp paper into the feed slot. It could wrap around the cutting unit and cause
a blockage.
- Do not feed paper with paper clips. This could damage the cutting unit.
- Do not feed more than 10 sheets of paper simultaneously into the feed slot. This could damage
the cutting unit.
To Next Page
Loading...
