Vacuum Cleaner
SVC 45BK / SVC 45BL / SVC 45GR / SVC 45RD / SVC 45WH
EN
EN-7
Copyright © 2014, Fast ČR, a.s. Revision 11/2014
Adjusting the fl oor inlet nozzle according to the fl oor surface.
You may set the inlet nozzle according to the fl oor surface by adjusting the inlet fl ap:
• If you want to vacuum carpets, close the bristles of the inlet inside the inlet nozzle, by turning the
fl ap accordingly.
• If you want to vacuum hard and smooth surfaces, move the bristles out of the nozzle, by turning
the fl ap accordingly.
Turning your vacuum cleaner on and off
To switch your machine on or off, press the START / STOP button on the vacuum cleaner body.
Adjusting the suction strength
Suction can be controlled by a sliding fl ap on the hose handle.
Tip:
If the hose holder becomes blocked when vacuuming, disconnect it from the tube and also
disconnect the hose from the vacuum cleaner body. Then place the holder inside the suction hole
on the vacuum cleaner body and vacuum the stuck dirt out.
Temporary interruption of the vacuuming process
If you wish to interrupt vacuuming for a short time, using the lug place the fl oor nozzle into the parking
position in its rear part.
Note:
Do not move the vacuum cleaner from place to place if the hose is in the parked position! You
may brake off the parking position holder!
Using your accessories
A space for the combination nozzle is located in the bottom part of the vacuum cleaner.
The combination nozzle may be used to vacuum in hard-to-reach spaces such as window frames,
libraries, upholstery corners, joints, etc.). By turning the brushes out you get a brush nozzle suitable for
vacuuming e.g. dust from smaller types of surfaces, grills, keyboards, etc.
C
Ending the vacuuming process
When you fi nish vacuuming, switch the vacuum cleaner off by pressing the START / STOP button and
then disconnect the power cord plug from the socket.
To wind the power cord back to the vacuum cleaner, press and hold the winding button with one hand.
Hold the cable with your other hand to protect the vacuum cleaner input area from damage.
To Next Page
Loading...
Need help?
General
