Sennheiser AMBEO Max - Auto Standby; Selecting Input Source

Operating the AMBEO Soundbar | Max
AMBEO Soundbar | Max | 37
Auto standby
If there is no playback for 20 minutes, the Soundbar automatically
switches to standby mode.
No playback:
• Bluetooth or Chromecast input is paused
• Bluetooth or Chromecast connection is disconnected
• Analog, optical or HDMI input: no playback available
Auto standby always activates the standby mode that was last used
(standby or standby without network connections).
The time after which the Soundbar switches to auto standby can be
adjusted via the Smart Control app.
Selecting the input source
If you want to change the input source, you have the following
options:
•Press the SOURCE button on the Soundbar.
•Press the SOURCE button on the remote control.
• Use the Smart Control app.
In addition to the ECO standby mode, you can switch off the
Soundbar and at the same time switch off all network connec
-
tions (> 36). In this mode, power consumption is minimal, but
the Soundbar must then be switched on on the device itself.
When playback is muted (“MUTE”), auto standby is not active.
WARNING
Danger of hearing damage due to high volume levels!
Listening at high volume levels for long periods of time can
lead to permanent hearing defects.
▷ Adjust the volume to a low level before selecting a
source.
▷ Do not continuously expose yourself to high volume
levels.