SENTRY II 940ST Series - Setting the Regeneration Time

16
Control Valve Programming
Setting the Regeneration Time
Step 1:
Press and hold the SET button and the UP arrow button at the same time (See
Fig. 1) for approximately 6 seconds to access the regeneration time setting. The hour
will begin flashing.
Hour
Minutes
Step 2: The hour will be flashing. Set the hour using the UP and DOWN arrows. (See
Fig. 2) This will set what hour regeneration begins. Press SET to go to the next step.
Step 3:
The minutes will be flashing. Set the minutes by using the UP and DOWN
arrows. Press SET to complete the regeneration time setting and to continue on to
program the regeneration frequency settings. (SEE NEXT PAGE)
The regeneration time has been set.
(Figure 1)
(Figure 2)