Sentry Sample Sentry II 5
Specications
Specications are subject to change without notice.
Applications: Sentry® Sample Sentry®II
is designed to meet requirements for
representative sampling by maintaining
a constant ow rate with varying inlet
conditions.
Models:
Low Pressure Models (LP)
100–500 psi (6.9–35 bar) at 450°F (232°C)
High Pressure Models (HP)
500–3000 psi (35–207 bar) at 1000°F (540°C)
Flow Control:
Range: 0–1500 cc/min
Accuracy: ± 50 cc/min
Measurements:
Final Sample Temperature
Cooling Water Outlet Temperature
Inlet Temperature to Secondary Cooler
Inlet Sample Pressure
Analyzer Sample Pressure
Sample Flow Rate
Pressure Measurements:
Range: 0–3000 psi (0–207 bar)
Accuracy: ± 0.5%
Temperature Measurements:
Range: 32–250°F (0–121°C)
Accuracy: ± 1°F
Alarm Relay Contact Rating:
Max. operating voltage: 250 VAC
220 VDC
Max. switching capacity: 30 W, 62.5 VA
inductive
60 W, 125 VA
resistive
Communications:
Protocol: MODBUS®
Network: RS-485
Display:
Graphical Vacuum Fluorescent Display
Power:
Input Voltage: 100–240 VAC
Frequency Range: 50/60 Hz
Input Current: 1.5 A / 115 V
0.9 A / 230 V
Compressed Air:
Consumption : < 0.2 scfm
Pressure: 80 psi minimum (5.5 bar)
120 psi maximum (8.3 bar)
Dimensions:
With sink
14 in x 43 in (356 mm x 1092 mm)
Without sink
14 in x 36 in (356 mm x 914 mm)
Mounting:
Wall mount using four 3/8" bolts
Ambient Temperature:
0–50°C (32–122°F) RH 95% max.
non-condensing at 40°C (104°F) max.
Approximate Shipping Weight:
65 lb max (29 kg)
To Next Page
Loading...
General