SentrySafe Quick Access Pistol - Bolt-Down Instructions; Bolting Down Your Safe

8 9
English
Bolt-Down Instructions
Drill the holes in the surface using the appropriate diameter and depth for the type of
hardware and the mounting surface being used.
A
Replace the safe over the newly created holes.
B
Install the screws and washers as required.
WARNING
SentrySafe is not responsible for costs incurred if the unit is to be replaced.
Bolting/unbolting the unit is at a consumer’s expense and discretion.
Bolting down your safe (Cont.)
3
4
Bolt-Down Instructions
Bolt down kit contents:
2 Lag screws
2 Washers
Tools needed to bolt safe to a surface:
Drill
Wrench
9/32" (7.2 mm) drill bit – for drilling into wood
3/8" (9.5 mm) drill bit – for drilling into masonry
Select a suitable location for your Quick Access Pistol Safe. Set
the safe in place, and use the pre-drilled holes provided on
the bottom of the safe to mark the location of the holes to be
drilled in the surface.
WARNING
Do NOT drill from any location inside the safe.
NOTE: This product is intended to be mounted with a horizontal orientation.
Move the Quick Access Pistol Safe while you drill the marked
holes in the surface.
Bolting down your safe
1
2