SolaStat™-1-3 Installation Guide
Version 1.1 – April 2013 Page 2
BEFORE YOU BEGIN INSTALLATION, CONTINUED
Assemble the
tools you will
need
You will need the following tools to install the SolaStat™:
Philips1 screwdriver for lid screws
Pozi 2 screwdriver for mounting screws
Note: These tools are needed to mount the SolaStat™ only, and other tools
may be needed for the remainder of the installation including the sensors.
READ THESE SAFETY PRECAUTIONS and LIMIT OF LIABILITY BEFORE YOU BEGIN
The following pages contain instructions for qualified personnel only. They involve potentially
hazardous adjustments and high voltage mains wiring information.
General
Safety
Precautions:
The following general safety precautions should be noted:
This installation guide is for the installation of SolaStat
TM
The complete installation should be checked at least annually for damage
or malfunction.
Controllers only and
is not an installation guide for any other part.
All servicing must be carried out by an authorised service agent only.
All aspects of the installation must comply with local electrical and
plumbing regulations (and any special solar hot water regulations).
Continued on next page
To Next Page
Loading...
