SEPTENTRIO PolaRx5TR Quick Start Guide

PolaRx
5TR
To set up the PolaRx5TR you will need:
Antenna
5
. Basic Monitoring
•
•
•
WiFi capable device
Antenna cable
USB cable
Power adapter
For more information:
The memory stick delivered with the PolaRx5TR
contains the following documents:
You can also consult our webpage or contact our
Support Department:
Is the PolaRx5TR tracking satellites?
•
Click 'Show table' on the
Spectrum plot then select
GPS L2-P(Y). This frequency
band can be vulnerable to
interference.
•
Select the 'GNSS' tab then 'Spectrum'
•
Select the 'GNSS' tab then
'Satellites and Signals'
•
In open sky, the PolaRx5TR
should track between 15
and 25 GPS and Glonass
satellites.
•
The Carrier-to-Noise plot
for GPS should show
about 3 satellites with an
L1CA above 50 dB-Hz
•
Quick Start Guide
PolaRx5TR User Manual
PolaRx5TR Firmware Manual
SBF Reference Guide
http://www.septentrio.com
The small GPS L2 signal at
1227.6 MHz should be visible.
Other spikes or anomalous
activity in the spectrum may
indicate interference.
Is there any interference?
•
or
support@septentrio.com

SEPTENTRIO PolaRx5TR Specifications

General

Brand	SEPTENTRIO
Model	PolaRx5TR
Category	Receiver
Language	English