www.servware.com
800•768•5953
Service, Installation & Care Manual
8
INSTALLATION
GAS CONVERSION
CLEANING
1. Ensure gas supply is on and ignite the pilot ame with a lighter. If the unit hasn’t been used in a
while or if this is the rst lighting, ignition might take a little longer (about two or three minutes).
2. Press the corresponding valve knob of burner and turn 90 degrees counterclockwise. The burner
will be ignited and the ame will be at Max. To set the ame to Min, rotate counterclockwise
another 90 degrees.
3. If the ame could not be maintained, turn burner off and wait 5 minutes, then repeat.
4. When nished turn off main burner by rotating the knob clockwise to off position. Pilot should
remain lit.
5. For complete shutdown, ensure that all burner knobs are turned to the off position, and then turn
main gas supply off.
Conversion from Natural Gas to Liquid Propane (LP) or vice versa may only be performed by the
factory or its authorized service agent.
NOTE: It is important to check the machine daily. Checking the machine regularly can avoid serious
accidents. Stop using if user feels that there are some problems with the unit. Check the condition of
the machine before and after using every day.
1. Before cleaning, turn off all gas valves.
2. Please clean the burners and drip tray of all debris and spillage daily. A complete cleaning every
day will ensure a good service and extend the service life of the unit.
3. Clean the stainless steel surface with warm soapy water every day and rinse it completely. Do not
saturate range with water, excessive water will cause operational issues. During cleaning, do not
clean the stainless steel surface with abrasive detergent, brush or scraper etc. The residual iron
scale may cause rusting.
4. Do not clean the surface with chlorine cleanser (bleach, dish detergent, hydrochloric acid etc.). Do
not clean the oor where the device locates with corrosive substance.
5. Do not change the burner shutter settings.
To Next Page
Loading...
