Server Technology PRO2 - Page 210

PRO2 User Guide
Chapter 8: Using the Command Line Interface (CLI)
• 210
Sub-Parameters
The set sensor command uses the following sub-parameters:
min <= alarmlo <= warnlo <= warnhi <= alarmhi <= max
Command Access
Command Syntax
set snmp iprestrict [none | trapdests]
set snmp syscontact <system contact>
set snmp syslocation <location>
set snmp sysname <system name>
set snmp trap dest1 <hostname>
set snmp trap dest2 <hostname>
set snmp trap format [v1 | v2c | v3]
set snmp trap repeat <repeat time>
set snmp v2 [disabled | enabled]
set snmp v2 [getcomm | setcomm | trapcomm] <comm string>
set snmp v3 [disabled | enabled]
The set snmp command uses the following parameters:
Sets to only allow to trap destinations to have SNMP access
System contact string. 0-63 characters.
System location string. 0-63 characters.
System name string. 0-63 characters.
Sets trap notification options.
Sets to allow access with SNMPv2.
Sets to allow access with SNMPv3.