Server Technology PRO2 - Page 237

PRO2 User Guide
Chapter 8: Using the Command Line Interface (CLI)
• 237
Command Syntax
show snmp
Command Access
Example
Switched PDU: show snmp
SNMP Configuration
SNMPv2 Agent: enabled
Get Community <RO>: public
Set Community <RW>:
SNMPv3 Agent: disabled
Engine ID: 8000006B602
RW User Name: <not set>
RW User Auth Method: none
RW User Auth Password: <not set>
RW User Privacy Pass: <not set>
RO User Name: <not set>
RO User Auth Method: none
RO User Auth Password: <not set>
RO User Privacy Pass: <not set>
SNMP Trap:
Format: v1
v2 Community: trap
v3 Username: <not set>
Destination 1:
Destination 2:
IP Restrictions: No Restrictions
Error Repeat Time: 60 second(s)
SNMP SysName: Sentry_60000a
SNMP SysLocation: FIRMWARE PIPS-POPS Switched 3P
SNMP SysContact: