Why is oil leaking from the breather valve on my SEW-Eurodrive KF67 Industrial Equipment?
If oil is leaking from the breather valve of your SEW-Eurodrive Industrial Equipment, it could be due to having too much oil. In this case, correct the oil level. Alternatively, the drive might be installed in an incorrect mounting position. To resolve this, fit the breather valve correctly and adjust the oil level.
How to troubleshoot unusual regular running noise in SEW-Eurodrive Industrial Equipment?
An unusual, regular running noise in your SEW-Eurodrive Industrial Equipment could be due to a meshing/grinding noise, indicating bearing damage. Check the oil and replace the bearing. Alternatively, a knocking noise might suggest an irregularity in the gearing.
What causes unusual irregular running noise in SEW-Eurodrive KF67?
An unusual, irregular running noise in your SEW-Eurodrive Industrial Equipment may be caused by foreign bodies in the oil. Check the oil.
Why is the output shaft not rotating on my SEW-Eurodrive KF67?
The output shaft of your SEW-Eurodrive Industrial Equipment not rotating, even when the motor is running or the input shaft is rotating, indicates that the shaft hub connection is interrupted in the gear unit.
General| Brand | SEW-Eurodrive |
|---|---|
| Model | KF67 |
| Category | Industrial Equipment |
| Language | English |
Explanation of safety and warning symbols used in the publication.
Initial safety considerations and general precautions for operation and maintenance.
Safety precautions for installing, starting up, and maintaining the gear units.
Detailed steps for mounting the gear unit onto its support structure.
Instructions for mounting couplings, hubs, or gears onto solid shafts.
Steps for installing and removing gear units with keyed or splined shafts.
Steps for removing gear units installed with the SEW mounting/removal kit.
Procedure for installing and removing gear units using shrink disc technology.
Steps for installing AM adapter couplings for IEC and NEMA motors.
Instructions for installing AQ adapter couplings, covering AQA and AQH designs.
Startup notes and running-in periods for helical-worm and Spiroplan® W gear units.
Startup guidance for helical, parallel shaft helical, and helical-bevel gear units.
Lists common gear unit problems, their possible causes, and recommended remedies.
Schedule and conditions for replacing gear unit lubricants.
Procedures for checking oil levels and changing the oil in gear units.
Recommended oil fill quantities for R.. and R..F helical gear units by mounting position.
Recommended fill quantities for F.., FF.., FA/FH/FV.. gear units by mounting position.
Recommended fill quantities for K.. helical-bevel gear units by mounting position.
Fill quantities for Spiroplan® (W-) and S.., SF.., SA/SH.. helical-worm gear units.
To Next Page