Why is oil leaking from the breather valve on my SEW-Eurodrive Industrial Equipment?
If oil is leaking from the breather valve of your SEW-Eurodrive Industrial Equipment, it could be due to having too much oil. In this case, correct the oil level. Alternatively, the drive might be installed in an incorrect mounting position. To resolve this, fit the breather valve correctly and adjust the oil level.
How to troubleshoot unusual regular running noise in SEW-Eurodrive KF87?
An unusual, regular running noise in your SEW-Eurodrive Industrial Equipment could be due to a meshing/grinding noise, indicating bearing damage. Check the oil and replace the bearing. Alternatively, a knocking noise might suggest an irregularity in the gearing.
What causes unusual irregular running noise in SEW-Eurodrive Industrial Equipment?
An unusual, irregular running noise in your SEW-Eurodrive Industrial Equipment may be caused by foreign bodies in the oil. Check the oil.
Why is the output shaft not rotating on my SEW-Eurodrive Industrial Equipment?
The output shaft of your SEW-Eurodrive Industrial Equipment not rotating, even when the motor is running or the input shaft is rotating, indicates that the shaft hub connection is interrupted in the gear unit.
Covers required tools, materials, pre-installation checks, and preparation.
Instructions for mounting the gear unit, breather valve, and painting.
Startup procedures and running-in periods for various gear unit types.
Identifies common gear unit problems, their causes, and recommended remedies.
Detailed steps for checking oil levels, consistency, and changing oil.
General| Brand | SEW-Eurodrive |
|---|---|
| Model | KF87 |
| Category | Industrial Equipment |
| Language | English |
To Next Page