Why is oil leaking from the breather valve on my SEW-Eurodrive Industrial Equipment?
If oil is leaking from the breather valve of your SEW-Eurodrive Industrial Equipment, it could be due to having too much oil. In this case, correct the oil level. Alternatively, the drive might be installed in an incorrect mounting position. To resolve this, fit the breather valve correctly and adjust the oil level.
How to troubleshoot unusual regular running noise in SEW-Eurodrive RF27?
An unusual, regular running noise in your SEW-Eurodrive Industrial Equipment could be due to a meshing/grinding noise, indicating bearing damage. Check the oil and replace the bearing. Alternatively, a knocking noise might suggest an irregularity in the gearing.
What causes unusual irregular running noise in SEW-Eurodrive RF27?
An unusual, irregular running noise in your SEW-Eurodrive Industrial Equipment may be caused by foreign bodies in the oil. Check the oil.
Why is the output shaft not rotating on my SEW-Eurodrive Industrial Equipment?
The output shaft of your SEW-Eurodrive Industrial Equipment not rotating, even when the motor is running or the input shaft is rotating, indicates that the shaft hub connection is interrupted in the gear unit.
General| Type | RF |
|---|---|
| Series | RF27 |
| Size | 27 |
| Gearbox Type | Helical |
| Output Shaft | Solid shaft |
Covers preliminary remarks, general safety, designated use, and transport/storage.
Safety during setup, installation, startup, operation, and maintenance procedures.
Illustrates basic designs of helical and parallel shaft helical gear units.
Details the basic design of helical-worm and Spiroplan® gear units.
Lists required tools, materials, and preparation steps for installation.
Covers installing gear units, solid shafts, torque arms, shrink discs, and adapter couplings.
Procedures for starting and running-in helical-worm, Spiroplan®, and other gear units.
Covers gear unit problems, inspection periods, maintenance, and lubricant replacement.
Explains the six standard mounting positions (M1-M6) for gear units.
Details approved lubricants, greases, and required fill quantities for gear units.
Lists addresses for SEW-EURODRIVE production, assembly, sales, and service worldwide.
To Next Page