Why is oil leaking from the breather valve on my SEW-Eurodrive Industrial Equipment?
If oil is leaking from the breather valve of your SEW-Eurodrive Industrial Equipment, it could be due to having too much oil. In this case, correct the oil level. Alternatively, the drive might be installed in an incorrect mounting position. To resolve this, fit the breather valve correctly and adjust the oil level.
How to troubleshoot unusual regular running noise in SEW-Eurodrive RF107 Industrial Equipment?
An unusual, regular running noise in your SEW-Eurodrive Industrial Equipment could be due to a meshing/grinding noise, indicating bearing damage. Check the oil and replace the bearing. Alternatively, a knocking noise might suggest an irregularity in the gearing.
What causes unusual irregular running noise in SEW-Eurodrive RF107 Industrial Equipment?
An unusual, irregular running noise in your SEW-Eurodrive Industrial Equipment may be caused by foreign bodies in the oil. Check the oil.
Why is the output shaft not rotating on my SEW-Eurodrive RF107 Industrial Equipment?
The output shaft of your SEW-Eurodrive Industrial Equipment not rotating, even when the motor is running or the input shaft is rotating, indicates that the shaft hub connection is interrupted in the gear unit.
General| Brand | SEW-Eurodrive |
|---|---|
| Model | RF107 |
| Category | Industrial Equipment |
| Language | English |
Explains hazard symbols like electrical, imminent danger, and damaging situations.
Discusses general safety aspects during operation, emphasizing qualified personnel and potential hazards.
Defines the intended industrial use and safety precautions for transporting and storing the gear units.
Guides users to relevant sections for safety notes on installation, startup, and maintenance procedures.
Outlines essential checks and general steps for mounting the gear unit correctly.
Details mounting input and output elements onto solid shafts, including couplings and hubs.
Explains how to harmonize distance, axial, and angular misalignment when installing couplings.
Details the process of installing and removing shaft-mounted gear units using keys or splines.
Continues the procedure for installing and removing shaft-mounted gear units with keys or splines.
Describes the steps for removing shaft-mounted gear units using the SEW installation/removal kit.
Explains the procedure for installing shaft-mounted gear units with shrink discs.
Details tightening torques for shrink discs and specifies lubricants for tapered surfaces.
Explains the running-in period and power reduction for helical-worm and Spiroplan® W gear units.
Outlines startup procedures for helical, parallel shaft helical, and helical-bevel gear units.
Provides a systematic guide to identifying and resolving common gear unit operational problems.
Outlines recommended intervals for inspections and a schedule for lubricant replacement based on conditions.
Gives detailed procedures for checking oil levels and for draining and refilling gear unit oil.
Explains the meaning of lubricant abbreviations and provides a legend for the lubricant table.
Comprehensive table listing approved lubricants from various manufacturers for different gear unit types.
To Next Page