Why is oil leaking from the breather valve on my SEW-Eurodrive RF147 Industrial Equipment?
If oil is leaking from the breather valve of your SEW-Eurodrive Industrial Equipment, it could be due to having too much oil. In this case, correct the oil level. Alternatively, the drive might be installed in an incorrect mounting position. To resolve this, fit the breather valve correctly and adjust the oil level.
How to troubleshoot unusual regular running noise in SEW-Eurodrive Industrial Equipment?
An unusual, regular running noise in your SEW-Eurodrive Industrial Equipment could be due to a meshing/grinding noise, indicating bearing damage. Check the oil and replace the bearing. Alternatively, a knocking noise might suggest an irregularity in the gearing.
What causes unusual irregular running noise in SEW-Eurodrive RF147 Industrial Equipment?
An unusual, irregular running noise in your SEW-Eurodrive Industrial Equipment may be caused by foreign bodies in the oil. Check the oil.
Why is the output shaft not rotating on my SEW-Eurodrive RF147?
The output shaft of your SEW-Eurodrive Industrial Equipment not rotating, even when the motor is running or the input shaft is rotating, indicates that the shaft hub connection is interrupted in the gear unit.
Describes hazard symbols (electrical, danger, warning) and operating hints.
Lists necessary tools, materials, and agents for installation.
Instructions for mounting the gear unit, including flange/leg considerations.
Details on installing input and output elements for solid shaft gear units.
Procedures for installing torque arms on shaft-mounted gear units.
Steps for installing/removing units with key or spline shaft connections.
Using the SEW kit for installing customer shafts with or without contact shoulders.
Procedures for removing gear units installed using the SEW mounting/removal kit.
Details the SEW installation/removal kit, including part numbers and dimensions.
Steps for installing and removing gear units using shrink disc technology.
Instructions for installing AM adapter couplings for IEC and NEMA motors.
Steps for installing AQ adapter couplings (AQA and AQH designs).
Instructions for mounting on AD input shaft assemblies.
Running-in period and power reduction for helical-worm and Spiroplan® W gear units.
Notes on startup for helical, parallel shaft helical, and helical-bevel units.
Table of common gear unit problems, their possible causes, and remedies.
Recommended intervals for checking oil and performing maintenance.
Procedures for checking and changing oil in gear units.
Comprehensive table of approved lubricants for various gear unit series and temperatures.
General| Series | RF |
|---|---|
| Size | 147 |
| Gearbox Type | Gearbox |
| Output Speed | Varies depending on specific configuration (rpm) |
| Mounting Type | Foot-mounted, flange-mounted, shaft-mounted |
| Protection Class | IP65 |
| Cooling Method | Natural Convection |
| Ambient Temperature | -20°C to +40°C |
To Next Page