Why is oil leaking from the breather valve on my SEW-Eurodrive R27 Industrial Equipment?
If oil is leaking from the breather valve of your SEW-Eurodrive Industrial Equipment, it could be due to having too much oil. In this case, correct the oil level. Alternatively, the drive might be installed in an incorrect mounting position. To resolve this, fit the breather valve correctly and adjust the oil level.
How to troubleshoot unusual regular running noise in SEW-Eurodrive Industrial Equipment?
An unusual, regular running noise in your SEW-Eurodrive Industrial Equipment could be due to a meshing/grinding noise, indicating bearing damage. Check the oil and replace the bearing. Alternatively, a knocking noise might suggest an irregularity in the gearing.
What causes unusual irregular running noise in SEW-Eurodrive Industrial Equipment?
An unusual, irregular running noise in your SEW-Eurodrive Industrial Equipment may be caused by foreign bodies in the oil. Check the oil.
Why is the output shaft not rotating on my SEW-Eurodrive Industrial Equipment?
The output shaft of your SEW-Eurodrive Industrial Equipment not rotating, even when the motor is running or the input shaft is rotating, indicates that the shaft hub connection is interrupted in the gear unit.
General| Brand | SEW-Eurodrive |
|---|---|
| Model | R27 |
| Category | Industrial Equipment |
| Language | English |
Please note the safety and warning notes in this publication!
List of tools, materials, and agents needed for installation.
Mounting instructions for gear units and geared motors.
Notes and steps for installing/removing units with key or splines.
Steps for installing/removing units with shrink disc.
Steps for installing AM adapter couplings (IEC and NEMA).
Steps for installing AQ adapter couplings (AQA and AQH).
Installing on AD input shaft assembly with motor mounting platform.
Problems, possible causes, and remedies for gear units.
Table of inspection/maintenance intervals and tasks.
Chart for oil replacement based on operating hours and temperature.
Procedures for checking and changing gear unit oil.
Designation of six mounting positions (M1-M6) for gear units.
Diagrams showing mounting positions for helical gear units (R..).
Diagrams showing mounting positions for parallel shaft helical gear units (F..).
Diagrams showing mounting positions for helical-bevel gear units (K..).
Diagrams showing mounting positions for helical-worm gear units (S..).
Information on lubricants and fill quantities for gear units.
Comprehensive table of lubricants for various gear unit types.
To Next Page