Why is oil leaking from the breather valve on my SEW-Eurodrive Industrial Equipment?
If oil is leaking from the breather valve of your SEW-Eurodrive Industrial Equipment, it could be due to having too much oil. In this case, correct the oil level. Alternatively, the drive might be installed in an incorrect mounting position. To resolve this, fit the breather valve correctly and adjust the oil level.
How to troubleshoot unusual regular running noise in SEW-Eurodrive Industrial Equipment?
An unusual, regular running noise in your SEW-Eurodrive Industrial Equipment could be due to a meshing/grinding noise, indicating bearing damage. Check the oil and replace the bearing. Alternatively, a knocking noise might suggest an irregularity in the gearing.
What causes unusual irregular running noise in SEW-Eurodrive R97 Industrial Equipment?
An unusual, irregular running noise in your SEW-Eurodrive Industrial Equipment may be caused by foreign bodies in the oil. Check the oil.
Why is the output shaft not rotating on my SEW-Eurodrive R97 Industrial Equipment?
The output shaft of your SEW-Eurodrive Industrial Equipment not rotating, even when the motor is running or the input shaft is rotating, indicates that the shaft hub connection is interrupted in the gear unit.
General| Brand | SEW-Eurodrive |
|---|---|
| Model | R97 |
| Category | Industrial Equipment |
| Language | English |
Covers general safety, designated use, and transportation/storage precautions.
Lists necessary tools, materials, and prerequisites before commencing installation.
Instructions for mounting the gear unit, including ventilation and component installations.
Guidance for installing solid shafts, couplings, and torque arms on gear units.
Procedures for starting up gear units, including running-in periods for specific types.
Identifies common gear unit problems, their causes, and recommended remedies.
Defines recommended intervals for checks, oil changes, and maintenance.
Introduces SEW's six mounting positions (M1-M6) and explains symbols.
Diagrams showing mounting positions for R and F series helical gear units.
Diagrams showing mounting positions for K and S series gear units.
Information on approved lubricants, greases, and recommended fill quantities.
To Next Page
