Why is oil leaking from the breather valve on my SEW-Eurodrive RX77?
If oil is leaking from the breather valve of your SEW-Eurodrive Industrial Equipment, it could be due to having too much oil. In this case, correct the oil level. Alternatively, the drive might be installed in an incorrect mounting position. To resolve this, fit the breather valve correctly and adjust the oil level.
How to troubleshoot unusual regular running noise in SEW-Eurodrive RX77?
An unusual, regular running noise in your SEW-Eurodrive Industrial Equipment could be due to a meshing/grinding noise, indicating bearing damage. Check the oil and replace the bearing. Alternatively, a knocking noise might suggest an irregularity in the gearing.
What causes unusual irregular running noise in SEW-Eurodrive RX77 Industrial Equipment?
An unusual, irregular running noise in your SEW-Eurodrive Industrial Equipment may be caused by foreign bodies in the oil. Check the oil.
Why is the output shaft not rotating on my SEW-Eurodrive Industrial Equipment?
The output shaft of your SEW-Eurodrive Industrial Equipment not rotating, even when the motor is running or the input shaft is rotating, indicates that the shaft hub connection is interrupted in the gear unit.
Key safety and warning notes for operating the gear units.
Required tools, materials, and initial checks before installation.
Procedures for mounting the gear unit and its components.
Identifies common gear unit problems and provides remedies.
General| Series | RX |
|---|---|
| Size | 77 |
| Ambient Temperature | -20 °C to +40 °C |
| Gearbox Type | Helical |
| Output | Shaft |
| Efficiency | Up to 98% |
| Protection Class | IP65 |
| Lubrication | Oil |
To Next Page