Sewha SI 4010 - Default Chapter; Table of Contents

DIGITAL WEIGHING INDICATOR
SI 4010
2
CONTENTS
1. Before Installation
---------------
3 page
2. Introduction
---------------
4 page
3. Specification
---------------
5 page
4. Installation
4-1. External Dimension & Cutting Size
4-2. Installation Components
4-3. Load Cell Installation
---------------
---------------
---------------
---------------
11 page
11 page
12 page
12 page
5. Set-up
5-1. Calibration
5-2. TEST Weight Calibration Mode
5-3. Simulation Calibration Mode(Without Test Weight)
5-4. Set-up
5-5. F-Function
---------------
---------------
---------------
---------------
---------------
---------------
13page
13 page
13 page
16 page
19 page
20 page
6. Interface
6-1. Serial Interface (RS-232C)
6-2. Current Loop Interface
6-3. Analog Output Interface (0~10V)
6-4. Analog Output Interface (4~20mA)
6-5. Serial Interface (RS-232C / 422 / 485)
6-6. BCD Input ( BCD INPUT : P/N Change)
6-7. BCD Output
6-8. Print Interface
6-9. Command Mode
---------------
---------------
---------------
---------------
---------------
---------------
---------------
---------------
---------------
---------------
27 page
27 page
31 page
32 page
33 page
34 page
35 page
36 page
37 page
38 page
7. Error & Treatment
7-1. Load Cell Installation
7-2. Calibration Process
7-3. Indicator Error & Treatment
7-4. Indicator Test Mode
---------------
---------------
---------------
---------------
---------------
40 page
40 page
40 page
41 page
42 page
Warrantee Certification
---------------
43 page