Sewha SI 4010 - Specification; Analog Input & A;D Conversion; Digital Part; General Specification

DIGITAL WEIGHING INDICATOR
SI 4010
5
3. SPECIFICATION
3-1. Analog Input & A/D Conversion
Input Sensitivity
0.2㎶ / Digit
Load Cell Excitation
DC 10V ( - 5V ~ + 5V )
Max. Input Signal
Max.3.2mV/V
Temperature Coefficient
[Zero] ±20PPM/℃
[Span] ±20PPM/℃
Input Noise
±0.3㎶ P.P
Input Impedance
Over 10㏁
A/D Conversion Method
Sigma-Delta
A/D Resolution(Internal)
520,000 Count(19bit)
A/D Sampling Rate
Max. 500times / Sec
Non-Linearity
0.005% FS
Display Resolution(External)
1/20,000
3-2. Digital Part
Display
Parts
Specification
Display
Main Display
7Segments, RED FND Display
Size :24.5mm(H) Large Display (1inch)
Min. Division
×1, ×2, ×5, ×10, ×20, ×50
Max. display value
+999,950
Under Zero value
"-" (Minus display)
Status lamp
Steady, Zero, Tare
Green LED Display(2Ø )
kg, g, ton
K e y
Number Key : 10 ea , Function : 3 ea , CAL. Lock key : 1 ea
3-3. General Specification
Power Supply
AC110/220V±10%), 50/60Hz, about 30VA
Operating Temperature Range
-10℃ ~ 40℃
Operating Humidity Range
Under 85% Rh (non-condensing)
External Dimension
200mm(W)ｘ105mm(H)ｘ165mm(L)
Net Weight(kg)
About 2.3kg
Gross Weight(kg)
About 3.0kg
※ AC 110V, Power supply is an optional before ex-factory.