WINDING THE BOBBIN
Note: Remove the fabric and the thread from Take-up lever, before
winding the bobbin
1. Pull out the thread spindle (on the top of the machine )then
put the spool on it. (Pic.l)
2. Press the winding pole of Hand-wheel and turn it counter
clockwise, the pole will automatically pop up. (pic.2)
3. Insert the empty bobbin in the winding pole.
4. Pull a thread from spool and wind it on the empty bobbin for
4-5 circles, then turn on the machine to begin the automatic
winding. Guide the winding with side-to-side movement to
feed the bobbin evenly.
5. After winding, you can restore the winding pole.
9
NEEDLE REPLACEMENT
Caution: Make sure to turn off the machine and plug out the adapter
before replacing the needle.
(1) Raise the needle to its highest position by turning the
hand-wheel and lay down the presser foot.
(2) Loosen the needle clamp screw by turning it
counterclockwise, and remove the needle from the clamp.
(3) Insert a new needle into the needle clamp with its flat side
towards the hand-wheel, which is very important
(Refer to Pic.1).
(4) When inserting the needle into the needle clamp, push it up
against the top, then tighten the needle clamp screw firmly.
DONE!
To Next Page
Loading...