BEFORE SEWING
(1) Check if the needle thread and bobbin thread are available.
The machine must be threaded correctly (Both needle thread and
bobbin thread, refer to Pages 6-7 "Threading the Machine"). A
wrong threading will cause skipped stitches (cannot sew), thread
breaking and irregular stitches.
(2) Check if the needle is threaded from left to right (the right side
is the Hand-wheel) refer to Pages 6-7 "Threading the Machine"
(3) Check if the needle is inserted in correct position (its flat side
towards the machine, refer to Page 9 "Needle Replacement").
(4) Check if the machine power is "OFF" (Automatic Sewing
Button), if not, turn the power switch OFF. IMPORTANT.
(5) Insert the Power Adapter into the machine socket on back of
machine
** IMPORTANT **
Note: AC Power Adapter and batteries CANNOT be
used at the same time.
(6) Insert the Power Adapter plug into the wall outlet.
(7) Insert the Foot Pedal into jack on back of machine, if you need
it.
** Note: Foot Pedal and On/Off Button (automatic) cannot be
used at the same time. **
START TO SEW
(1) Raise up the presser foot by pulling its lever, raise the needle
up to its highest position by turning the Hand Wheel towards you.
(2) Pull at least 10 cm (4 inches) needle thread from needle. Put
the needle thread and bobbin thread under and behind the press-
er foot.
(3) Insert the fabric under the presser foot.
(4) Lay down presser foot.
4
To Next Page
Loading...