5
FINISH SEWING
1. After your finished sewing, raise up the Presser Foot, and raise
up the needle to its highest position by turning the Hand-wheel.
2. Pull the fabric gently, DO NOT pull it by force, otherwise it will
warp or break the needle. You can turn the Hand-wheel up and
down during pulling the fabric. If the threads are too tight, pull
some needle thread from theTake-up Lever.
3. Cut the threads by using its Cutter on the machine or scissors.
4. Remember to unplug the machine from electrical outlet, when
you do not need to use it again.
START TO SEW
(1) Raise up the presser foot by pulling its lever, raise the needle
up to its highest position by turning the Hand Wheel towards you.
(2) Pull at least 10 cm (4 inches) needle thread from needle. Put
the needle thread and bobbin thread under and behind the press-
er foot.
(3) Insert the fabric under the presser foot.
(4) Lay down presser foot.
(5) Select sewing mode------ Foot Pedal, or On/Off Button (auto-
matic). Select the speed (slow or fast) according your need.
IMPORTANT: Foot Pedal and On/Off Button cannot be used
at the same time.
(6) Sew some stitches on the fabric manually by turning
Hand-wheel towards you to stabilize the stitches. IMPORTANT!
(7) Turn it on by Auto-sewing button or Foot Pedal to sew.
Note: It is suggested that you try some sewing on a test
fabric to adjust the thread's tension accordingly. (Page.5
"Adjust Thread Tension")
(8)Switch off the machine immediately when encountering thread
breaking or jamming.
To Next Page
Loading...