SewMighty Mighty Mini - Threading the Machine

THREADING THE MACHINE
1. Set the Needle Thread ( Upper Thread )
Please strictly follow the right order to thread the needle
thread as illustrated.
Start from Upper Bobbin (the bobbin must be placed clockwise)
the thread must go through：
①Eyelet
 ②Tension Screw (The thread must be placed between the
clamps, NOT in the spring)
③Eyelet
④Hole of theTakeup Lever
⑤Eyelet
⑥Needle Bar
⑦Needle IMPORTANT: thread the needle from left to
right. You can use the Needle Threader (included in
accessories) to thread the needle.
2. Draw up the Bottom Bobbin Thread
Before drawing up the bottom bobbin thread, pull out at least
10cm (4 inches) needle thread from the needle.
(1) Slide outward the bottom bobbin cover plate, and place the
bobbin in the bobbin holder. IMPORTANT: the bobbin should be
positioned clockwise. (Pic. 1)
(2) Pull about 7cm (3 inches) thread from bobbin and lay it on the
slot.
(3) Lay down Presser Foot, hold the needle thread lightly with
your left hand.
(4) Turn the Hand-wheel slowly towards you one complete round.
Draw up the bobbin thread by pulling up the needle thread with
you left hand as illustrated. (Pic.2)
6