To Next PageTo Next Page
Need help?Do you have a question about the SFA SANICOM1 1332 and is the answer not in the manual?
General| Motor Power | 400 W |
|---|---|
| Voltage | 220-240 V |
| Frequency | 50 Hz |
| Discharge Pipe Diameter | 32 mm |
| Maximum Water Temperature | 35 °C |
| Max Flow Rate | 100 L/min |
| Power | 400 W |
| Inlet/Outlet Size | 32 mm |
| Max Liquid Temperature | 35°C |
| Protection Rating | IP44 |
General safety advice for device usage by children and people with reduced capacities.
Electrical installation must be done by a qualified engineer.
Defines the meaning of warning symbols used in the manual.
Important instructions for fitting, operation, maintenance, and acceptable applications.
Requirements for qualified personnel and safety during maintenance and installation.
Outlines warranty loss and liability for not following the manual.
Procedures for checking goods upon receipt and safe transport methods.
Guidelines for storing the unit and proper environmental disposal.
Explains how Sanicom 1 and Sanicom 2 pumps operate, including alarm systems.
Table containing specifications like voltage, height, power, temperature, and weight.
Details on installation space, isolation valves, fitting on ground, and mounting.
Specifies not to use the station as a control point and to use flexible, noise-preventing connections.
Details on discharge outlets, non-return valves, and fitting a shutoff valve.
Explains the need for free ventilation and proper venting to the roof.
Instructions for making the electrical connection after plumbing is complete.
Steps for checking connections, water tightness, and performing start cycles.
Instructions for stopping water flow during power failure and warnings about hot surfaces.
Details on keypad operation, LED indicators, and general alarms for Sanicom 1.
Explains remote box operation, LED indicators, general alarms, and alarm reset for Sanicom 2.
Information on connecting an external alarm signal to Sanicom 2.
