SFA SANICUBIC GR Series User Manual (English)

Questions and Answers:

M
Maria SchroederAug 5, 2025
Why is my SFA SANICUBIC GR motor not running?
- J
  Jeremy FriedmanAug 5, 2025
  Several factors can cause the motor of your SFA Water Pump not to run. It could be due to voltage issues (too low or a complete lack of voltage), in which case you should check the main supply. Other potential causes include a wrong power connection (requires correction), a defective electric cable (requires replacement), a fault at the condenser (requires replacement), a blocked rotor (needs cleaning), a switched-off motor protection system due to overheating, blocking, or voltage error (needs checking), a control system error or defective pressure switch (needs checking), leaking pneumatic hose or connection (needs checking or replacement), or a defective motor (requires replacement).
S
Shannon RiveraAug 12, 2025
What to do if my SFA SANICUBIC GR motor is running but not conveying?
- C
  Cheryl MartinAug 12, 2025
  If the motor of your SFA Water Pump is running but not conveying, the issue might stem from several causes: * The rotor could be stopped up or worn, requiring cleaning or replacement. * The back-kick flap, gate valve, pressure main, or suction joints might be fowled up, needing cleaning (and opening the gate valve if it's closed). * The rotational direction could be wrong, needing correction. * The chamber ventilation or pump housing ventilation might be stopped up, also requiring cleaning.
M
mhartAug 20, 2025
Why does my SFA Water Pump motor run then switch off?
- E
  Eugene WhitneyAug 20, 2025
  If your SFA Water Pump motor runs and then switches off, it could be due to a voltage error or fluctuations, which needs correction. Another possible reason is that the thermo-protection is wrongly set, which needs checking.
D
dianepatelAug 27, 2025
What to do if SFA Water Pump motor does not switch off?
- B
  brewerandrewAug 27, 2025
  If the motor of your SFA Water Pump does not switch off, it could be due to a control system fault or the pressure switch function not being in order.

SFA SANICUBIC GR Series Specifications

General

Brand	SFA
Voltage	220-240 V
Max Head / Maximum vertical discharge	11 m
Maximum horizontal discharge	110 m
Liquid Temperature	35 °C
Number of available inlets	4
Ingress Protection	IP68
Model	SANICUBIC GR
Type	Grinder Pump
Flow Rate	11 m³/h
Outlet Diameter / Discharge pipe diameter	50 mm