SFA SANICUBIC 2 VX User Manual

CUBIC 2 VX
04.19
279
SANICUBIC 2 VX
®
IMPORTANT
DO NOT RETURN ANY MERCHANDISE TO THE VENDOR
NE PAS RETOURNER DE MARCHANDISE AU VENDEUR
For Customer Service, Returns or Technical Questions, please call Saniflo’s Technical Support toll-free at
800-571-8191 (USA) or 800-363-5874 (CDN).
Pour le service client, les retours ou toute question technique, merci d’appeller le service technique de Saniflo
au numéro suivant : 800-363-5874 (CDN).
This product must be installed in strict accordance with local plumbing codes.
Product should be installed by a licensed plumber.
Le produit doit être installé dans le respect des règlements sanitaires locaux.
Le produit doit être installé par un plombier qualié.
C
US
USA CDN

SFA SANICUBIC 2 VX Specifications

General

Type	Submersible Pump
Motor Power	1.1 kW
Voltage	230 V
Outlet Diameter	50 mm
Maximum horizontal discharge	50 m
Number of inlets	1
Protection rating	IP68
Alarm	Yes
Inlet Diameter	50 mm

Summary

SANICUBIC 2 VX Technical Data

Specifications and Flow Curves

Lists detailed technical specifications for SANICUBIC® 2 VX models, including electrical data and performance curves.

Safety Precautions and Warnings

Hazard Identification and General Safety

Identifies warning symbols, general safety points, and risks associated with non-compliance.

Intended Use and Maintenance Safety

Technical Data and Specifications

Model-Specific Technical Data

Lists detailed technical specifications for SANICUBIC® 1 VX and 2 VX models.

Control and Alarm Unit Specifications

Installation and Connection Guidelines

Station Installation and Electrical Setup

Covers installing the pumping station and its electrical connection requirements.

Pipe Connection Procedures

Commissioning and Operation Procedures

Pre-Commissioning and Application Limits

Outlines prerequisites for commissioning, application limits, and starting frequency.

Operation and Decommissioning Steps

Control Box and Alarm Unit Functionality

SANICUBIC® Control Box Operation

Alarm Unit and Fault Indication

Maintenance and Motor Servicing

General Maintenance and Contract

Motor Checks and Reassembly

Checklists and Troubleshooting Guide

Commissioning and Inspection Checklist

Troubleshooting Common Incidents

Lists common problems, their causes, and recommended solutions.