75
The SGC Building, 13737 S.E. 26th St. Bellevue, Washington 98005 USA
P.O. Box 3526, 98009 Tel: (425) 746-6310 Fax: (425) 746-6384
© 1997 SGC Inc.
The remote control head can easily be connected to the 10-pin connector located on the back panel of the
SG-2000. The remote control is connected to the main unit via a 10-wire control cable. This cable is with wire
and not fiberoptic cable so that it can quickly be field repaired if it becomes damaged. If more than one remote
control head is used, then a junction box can be plugged into the 10-pin socket. This junction box can accommodate
the connection of up to eight more remote control heads. For information on installing the remote control head kits,
see the SG-2000 manual.
CONNECTING THE REMOTE CONTROL
To Next Page