PAGE 19
PAGE 18
OPERATION
ADJUSTING THE LINE LENGTH
• Your brush cutters are equipped with a semi- auto type
nylon line head that allows the operator to advance the line
without stopping the engine. When the line becomes short,
lightly tap the head on the ground while running the engine
at full throttle.
• Each time the head is bumped, the line advances about
1 inch (25.4 mm). For better effect, tap the head on bear
ground or hard soil.
OPERATION
Choose a suitable recommended cutting attachment
according to the object to be cut.
Use the front left side cutting. Guide the blade from your right
to left with it tilted slightly to your left.
When mowing a wide area, start working from your left end to
avoid interference of cut grass.
Adjust the engine speed and cutting depth according to the
condition of object.
WARNING: If the grass or other object gets caught in the
blade, or if the unit starts to shake or vibrate, turn off the
engine and check the whole unit. Change the blade
if it has been damaged. Turn off the engine and make sure the
blade has completely stopped before checking the blade, and
removing any object got caught in.
WWW.SGS-ENGINEERING.COM
CALL FOR ASSISTANCE: 01332 576 850
To Next Page
Loading...
