PAGE 29
PAGE 28
MAINTENANCE
BLADES
When refilling the tank or resting, it is often a good idea to use the
time to oil the cutting blades. If a gap exists between the upper
and lower blades, follow the procedure below to adjust them so
that they fit more closely together.
1. Loosen lock nut (A) as shown in the diagram.
2. Tighten screw (B) fully, and then turn one-third to onehalf
of a rotation backward.
3. While holding onto the screw to keep it in position, tighten
the lock nut.
4. Check to make sure that the flat washer (C) is loose enough
so that it may be turned by pressing on it with a finger.
Storage & Disposal
Aged fuel is one of major causes of engine starting failure.
Before storing the unit, empty the fuel tank and run
the engine until it uses all the fuel left in the fuel line and
the carburetor. Store the unit indoor taking necessary
measures for rust prevention. When disposing your machine, fuel
or oil for the machine, be sure to allow your local regulations.
TROUBLESHOOTING
WWW.SGS-ENGINEERING.COM
CALL FOR ASSISTANCE: 01332 576 850
To Next Page
Loading...
