NFC Quick Pairing
Pairing Timeout
Switch the UP4 into pairing mode. Make sure you have NFC enabled on
your Android device. Bring your device to the NFC sensor on the UP4 to
initiate quick pairing.
If no device is paired with the Shanling UP4 in 5 minutes after entering
the pairing mode, Shanling UP4 will automatically power off.
Pairing process
While the Shanling UP4 is in pairing mode, turn on Bluetooth on your
device and search for available Bluetooth devices. Click on "Shanling
UP4(22)" to finish pairing process. If the pairing was successful, the
indicator will flash blue light every 5 seconds.
Disconnection
1. If the distance between the Shanling UP4 and the connected device is
beyond the effective connection range, the Shanling UP4 will
automatically power off after 10 minutes.
2. If you manually turn off Bluetooth on the connected device, the
Shanling UP4 will automatically enter pairing mode and if no new
device is connected within 5 minutes, the Shanling UP4 will power off
automatically.
To Next Page
Loading...
