SHARE AGV - Audio Control; Volume Adjustment

To Next Page

To Previous Page

AGV

- 9 -

Clear All Pairing Devices

In power on and without any active phone call, press and hold both ! (MFB button) and ! (MINUS

button) together for 6 seconds; when the Red LED flashes 2 times release buttons and, after all paring

devices have been cleared, the SHARE headset will automatically power off.

Audio control

Volume Up or Down

In any audio active state, press and hold " (PLUS button) to increase the volume of the corresponding

audio source; press and hold ! (MINUS button) to decrease the volume of the corresponding audio

source. Release the button when the volume reaches the desired level. When the maximum or minimum

volume is reached, a “MAXIMUM VOLUME” or “MINIMUM VOLUME” message is prompted.

The volume of each audio source（two phones, two music, intercom, FM Radio, Aux in）can be

individually tuned, i.e. 7 different independent volume parameters can be used.

Volume Levels Automatic Save

All favorite volume levels for each audio source are saved by the SHARE headset at the power off, so at

next power on, the SHARE headset can automatically set the last user favorite volume level, without any

operation required by the user.

Automatic Noise Dependent Volume Control

During phone calls, intercom calls or GPS audio messages, if the wind noise or environment noise is very

high and the current volume is not at maximum level, the SHARE headset will automatically increase the

volume level according to the noise level, and when the noise disappears for a while, the volume

automatically returns to the original level.

Mono/Stereo

NOTE

If the connection with a previously paired device doesn’t take effect, it can be due to several reasons,

including a crash of the Bluetooth

feature on the device to be connected. To solve this issue, there are

several actions to apply:

• Switch off and on the SHARE headset

• Switch off and on the Bluetooth

feature on the device to be connected

• Repeat the pairing procedure

• Clear all pairing list on the device to be connected and repeat the pairing procedure