SHARE AGV - Three-Way Call Management

AGV
- 13 -
While the SHARE headset is connected with the mobile phone and system is idle (no intercom, music, FM
Radio or Aux audio is playing) , quick double press ! (MINUS button) then the Mobile phone will dial
the last number called.
If the SHARE headset is in active intercom mode, first close the intercom session by short pressing the #
(CTRL Button), then the last number redial function can be normally used. If the SHARE headset is in
music, FM Radio or Aux in mode, first pause/mute such mode by short pressing the ! (MFB button).
If there are two mobile phones connected at same time with the SHARE headset, the number of the last
outgoing call is dialed on the same phone that dialed the last outgoing call; if no calls have yet been dialed,
the last number dialed with first connected mobile phone is dialed.
Voice Dial
While the SHARE headset is connected with the mobile phone and system is idle (no intercom, music, FM
Radio or Aux audio is playing) , quick double press " (PLUS button) then the mobile will prompt you
to speak out your desired voice command.
If the SHARE headset is in active intercom mode, first close the intercom session by short pressing the #
(CTRL Button), then the voice dial function can be normally used. If the SHARE headset is in music, FM
Radio or Aux in mode, first pause/mute such mode by short pressing the ! (MFB button).
If the voice dial function has been erroneously activated, double press " (PLUS button) again to cancel
it.
If there are two mobile phones connected at same time with the SHARE headset, the voice dial command
is initiated on either the first connected mobile phone or the last phone on which an outgoing call was
made.
Three Way Call Or Call From Two Mobile Phones
The following operations refer to the case with 2 mobile phones connected to SHARE headset and there is
an already active call on one of them:
1) Accept incoming call on the other mobile phone, hold active call
Short press the ! (MFB button) once to keep the current active call on hold and accept the incoming
call;
2) Accept incoming call on the other mobile phone, hang up active call
Quick double press the ! (MFB button) once to hang up the current active call, and accept the
incoming call;
3) Switch between two calls
With two calls (one active and one held), press the ! (MFB button) once to place the active call on
hold state; press again the ! (MFB button) once to switch back to the original active call and held
NOTE
Please make sure your mobile phone supports Voice Dial before activate Voice Dial function. Be
careful each mobile phone has a proper voice command to effectively start a new call. Read carefully
your mobile phone user manual in order to use the voice call function.
Anyway voice dial features and their usage (e.g. also the voice dial procedure cancellation) are
strongly dependent on the mobile phone.